been running thru a cage design for the last week or so now this picture sucks but, i think i may have it right, but i'm thinking of only putting 1 support in the middle on the bottom, since it's going to be framed, there shouldn't be an issue with sagging, but going to use 1x8's for the frame, then cover with the shower board on the top of the bottom, both outside and inside of the sides, and the top and bottom of the top piece, then ofcourse one piece for the back, but the dimensions are screwing me up, i want a 4' cage but to me 4x2x2 just doesn't seem to be deep enough i dont know, any thoughts? but this is an actual picture of a design edited in paint, and i dont have a piece made for the side but that's just a box frame with a support in the middle that just slides in , then i have a problem with making the front lol i am pretty sure i'll be able to make this "box" easially but it's the fron that will cause me problems. reason why i want to put just 1 support in the bottom ( to make it like the top , or may put 2 in top 1 in bottom) is for flexwatt, if i have 2 supports, only 1/3 of the cage will be heated
